Worth Data RF Terminal 7000 Owner's Manual page 55

ComStopBits
Valid values: 1, 2
Definition: This is a serial port setting and must match the base station setting. WDterm may allow
Quiet
Valid values: True, False
Definition: If
Methods – ActiveX Object
Methods are commands that you issue to the WDterm control. All of the "
terminal to wait for operator input.
Note that your development environment may show more available methods for the WDterm control than
are listed here. This is normal. You may ignore methods you see that are not listed here.
Important: When your application starts up, the serial port is "closed". You must call
method calls will work.
Except for the
ReInitAll
OpenDevice
Function:
CloseDevice
Function:
InputAny
Parameters: line, position, prompt, shifted, timestamped
InputAnyColor (15-line terminal only)
Parameters: line, position, prompt, shifted, timestamped,FG,BG
Function:
other settings but those listed here are the only ones compatible with current version
base stations.
is set to True then any status and error message generated by WDterm will be
Quiet
suppressed.
method, all methods use the
Color Codes for 7001
(15-line) Terminal
0 - aqua
1 - black
2 - blue
3 - fuchsia
4 - gray
5 - green
6 - lime
Opens the communications (serial) port. This must be called before any of the methods
described below. Make sure to set all Properties as desired before calling this method
(except
ActiveTerminal
Closes the communications (serial) port. This must be called before changing any of the
Property settings (except
serial port is "closed". You must call
This instructs the
ActiveTerminal
data to be entered from either terminal keypad or scanner. If shifted is set to "true", the
terminal will start in shifted mode. Timestamped appends a (hhmmss) prefix to the
returned data.
ActiveTerminal
7 - maroon
8 - navy
9 - olive
10 - purple
11 - red
12 - silver
13 - teal
14 - white (white)
15 - yellow
or ).
Quiet
or
ActiveTerminal Quiet
OpenDevice
to display the prompt at line and position and wait for
" commands cause the
Inputxxx
OpenDevice
property to identify the terminal to use.
). When your application starts up, the
before other method calls will work.
before other