Emergency Stop Signal System - Mazda CX-3 Owner's Manual

When Driving
Brake
If the AUTOHOLD switch is pressed
without depressing the brake pedal
while the AUTOHOLD is operating
(AUTOHOLD active indicator light is
turned on), the brake pedal operation
demand indicator light (green) in the
instrument cluster turns on to notify the
driver that it is necessary to depress the
brake pedal.
(Green)
If any of the following conditions occurs
while the AUTOHOLD function is
operating (AUTOHOLD active indicator
light is turned on), the parking brake is
applied automatically and the
AUTOHOLD function turns off. For the
Electric Parking Brake (EPB)
operation, refer to the Electric Parking
Brake (EPB) on page 4-78.
The ignition is switched OFF.
There is a problem with the
AUTOHOLD function.
Turn off the AUTOHOLD before
switching OFF the ignition so that the
parking brake is not applied
automatically.
4-86
CX-3_8GT4-EE-18D_Edition8_old
Emergency Stop Signal
System
If you apply the brakes suddenly while
driving at a speed of about 55 km/h (34
mph) or faster, the emergency stop signal
system automatically and rapidly flashes
all the direction indicator lights to caution
drivers behind your vehicle of the sudden
braking situation.
NOTE
Flashing
When you bring your vehicle to a
complete stop while all the direction
indicator lights are flashing rapidly, the
rapid flashing of all the direction
indicator lights changes back to the
normal flashing pattern. When the
hazard warning light switch is pressed,
all of the direction indicator lights turn
off.
Operation
When the ABS operates, the
emergency stop signal system is more
likely to operate. Therefore, if the
brake pedal is depressed on a slippery
road, all of the direction indicator
lights may flash.
The emergency stop signal system
does not operate when the hazard
warning light switch is pressed.
2019-11-14 12:53:52