Mazda CX-3 Owner's Manual page 678

CAUTION
Align the notch on the wheel cover with
the valve stem when installing it.
Notch
Tyre valve
Damage could occur during
installation if the wheel cover is not
properly aligned.
2. Loosen the wheel nuts by turning them
anticlockwise one turn each, but do not
remove any wheel nuts until the tyre
has been raised off the ground.
3. Place the jack on the ground.
CX-3_8GT4-EE-18D_Edition8_old
4. Turn the jack screw in the direction
shown in the figure and adjust the jack
head so that it is close to the jack-up
position.
Jack head
5. Place the jack under the jack-up
position closest to the tyre being
changed with the jack head squarely
under the jack-up point.
If Trouble Arises
Flat Tyre
Jacking position
7-17
2019-11-14 12:53:52