Advertisement
5 Start Up
5
Start Up
Drive Setup Procedure
The illustration below shows the basic setup procedure. Each step is explained more detailed
on the following pages.
* b1-01, b1-02 for frequency reference and RUN command source
* H1-
* Frequency reference values
* C1-
Run the motor without load, check the operation and verify, if the
upper controller (e.g. PLC, ...) commands to the drive work as
Fine tune and set application parameters (e.g. PID, ...) if necessary.
EN 34
YASKAWA Europe TOEP C710606 101A - V1000 MMD IP65 Motor Mounted Drive - Quick Start Guide
Install and wire the drive as explained.
Turn the power on.
Set/check the basic parameters:
, H2-
, H3-
, H4-
, C2-
for Acceleration/Deceleration times and S-curves
Connect the load, run the motor and check the operation
Final check the operation and verify the settings.
Drive is ready to run the application
START
, H6-oo to configure the I/Os
desired.
Advertisement
