Advertisement
4
Keypad Operation
LED Operator and Keys
The LED operator is used to program the drive, to start/stop it, and to display fault informa-
tion. The LEDs indicate the drive status.
Item
Name
Keys
ESC Key
Returns to the previous menu.
Moves the cursor to the right.
RESET Key
Resets a fault.
Starts the drive in the LOCAL mode. The Run LED
RUN Key
Up Arrow Key Scrolls up to select parameter numbers, setting values, etc.
Down Arrow
Scrolls down to select parameter numbers, setting values, etc.
Key
STOP Key
Stops the drive.
ENTER Key
Selects modes, parameters and is used to store settings.
LO/RE Selec-
Switches drive control between the operator (LOCAL) and
tion Key
the control circuit terminals (REMOTE).
Displays
Data Display
Displays the frequency reference, parameter number, etc.
Area
ALM LED
Flashing: The drive is in an alarm state.
Light
On: The drive is in a fault state and the output is stopped.
REV LED
On: The motor rotation direction is reverse.
Light
Off: The motor rotation direction is forward.
On: The drive is ready to operate the motor.
DRV LED
Off: The drive is in the Verify, Setup, Parameter Setting or
Light
Auto tuning mode.
On: The output frequency is displayed on the data screen.
FOUT LED
Off: Anything else than the output frequency is displayed on
Light
the data screen.
On: The drive is in the LOCAL mode (operation from key-
LO/RE LED
pad)
Light
Off: The drive is in REMOTE mode.
YASKAWA Europe TOEP C710606 101A - V1000 MMD IP65 Motor Mounted Drive - Quick Start Guide
• is on, when the drive is operating the motor.
• flashes during deceleration to stop or when the frequency
reference is 0.
• flashes quickly the drive is disabled by a DI, the drive was
stopped using a fast stop DI or a run command was active
during power up.
4 Keypad Operation
Function
2
3
4
9
1
6
5
8
7
EN 31
Advertisement
