10 Storage
When finished using the vacuum cleaner, empty the dust canister and clean
the filters.
You can either recharge the battery first, or store it away in a dry cool place.
Switch of and unplug the battery charger when not in use, or when fully
charged.
10.1 Wall Mount
There is a Charging Dock / Storage Bracket supplied
with screws and wall plugs should you prefer to hang the
vacuum cleaner on the wall.
To install the Charging Dock / Storage Bracket position the Charging Dock
/ Storage Bracket on the wall, near a power point and at a suitable height
where the vacuum cleaner will not touch the floor.
Mark the screw holes through onto the wall.
Using a suitable drill (wood drill bit for timber wall, or masonry drill bit for
brick / concrete walls, drill holes Ø6mm and 35 - 40mm deep.
Insert the plastic wall plugs into each hole and gently hammer in until they
are flush with the wall, place the Charging Dock / Storage Bracket over the
holes then insert the screws and tighten up. Do Not Overtighten.
Hang the vacuum cleaner as shown:
Front View
Side View
Page 22 of 24