Page 1
Wet & Dry Vacuum Cleaner for Indoor and Patio use For Household Use Only Model No.: MC609 Rev 1 Note: The specifications and/or components of this appliance are subject to change without prior notice. If the Hose, Floor Head or any Accessories should fail during use, please call 1800 079 124 for an immediate replacement.
Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Page 4
DO NOT use the vacuum cleaner if the appliance malfunctions, abnormal noise, smell, smoke, is dropped or damaged in any manner or any breakage is found during operation. For electrical safety, any repairs to the product must be performed by a qualified electrical person only, or the product must be disposed of.
Page 5
DO Keep cord away from heated surfaces. DO Keep all openings free of dust, lint. hair, and anything that may reduce airflow. DO use extra care when vacuuming on stairs. DO keep your work area well lit. DO store your appliance indoors in a cool. dry area. DO ensure children and babies cannot play with plastic bags or any packaging materials.
Transporting your Vacuum To move your vacuum cleaner from room to room, unplug the unit and carry using the carry handle only. Never pull or carry the vacuum cleaner by its power cord. Never carry the vacuum cleaner by the flexible hose. Components Carry Handle Floor Head –...
Side Clamps To remove the Upper Motor Housing from the Lower Dust Canister, the two side clamps need to be unlatched and lifted away from the clamping blocks. To do this, grasp the lower section of the clamp lever and lift outward and up then drop down as shown.
Page 8
IMPORTANT: This Product can be used for vacuuming up small liquid spills only. It is NOT designed to be used as a pump to empty water containers, pits, sinks, or the like. The Float Post has a small float inside. (image on the right shown without filters fitted for clarity).
Fitting Flexible Hose Fully insert the coupling end of the vacuum cleaner hose into the Hose Connector hole, align the tabs with the slots, and push in hard until it locks into place. To remove the flexible hose from the vacuum cleaner, press the side buttons to release the locking mechanism, and then pull the coupling straight out.
Power and Power Cord Before using the appliance, ensure the power cord is fully unwound. • Plug into the power point and switch on. • Press the On / Off button to start the motor. • Press again to Turn Off •...
Safety Devices Operation NOTE: The motor has an overheating protection device built in. It will automatically switch off power to the motor if it overheats. e.g., from blocked nozzles, a full Dust Canister or uncleaned and blocked filters. If this happens, turn off the vacuum cleaner and unplug from the power socket, clean blockage and / or filters and allow to rest for at least 60 minutes which should be enough time for the motor to cool down.
11 Blow Function This appliance has a “Blow” function where the air being blown out the air outlet port and be used for different purposes. The flexible hose can be attached to the Air Outlet Port in the same manner as connecting to the Suction Inlet on the front on the appliance.
12.1.1 Black Foam Filter Remove the Filter assembly as described in the section “Fitting the Filters” Remove the Black Foam Filter by sliding or rolling off the outside of the White Filter. Wash the black foam filter in warm mild soapy water, rinse in clean fresh cold water and let completely dry.
12.2 Cleaning the Vacuum Cleaner Body and Tools Do Not clean the vacuum cleaner, components or accessories using petrol or any other flammable liquid or solvents, etc. Clean the vacuum cleaner motor housing (Top Section), components and accessories using only a moist cloth and mild detergent. The Dust Canister can be washed inside and out but must be fully dry before re-assembling the top Motor Housing section.
14 Troubleshooting Clean the Filters and empty the Dust Canister Noisy operation Check for partial blockages and unblock. Clean the Filters and empty the Dust Canister. Weak Suction Check for blockages and unblock Check that the Suction Relief Valve on the hose handle is closed. Clean the Filters, empty the Dust Canister, check for blockages Over-heating / Stopping and unblock, then allow it to cool for up to hour before trying to...
15 Warranty Against Defect 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where...
Need help?
Do you have a question about the MC609 and is the answer not in the manual?
Questions and answers