Diagnostic Settings Submenu; Platform Trust Technology Submenu - Efco SmartSL User Manual

6.4.25

Diagnostic Settings Submenu

Feature Options
Disabled
Relay Interface
BC Diagnostic
Console
Primary Port Address Low
byte
Primary Port Address High
byte
Relay Device Address
(Dec)
BC Diagnostic Console Disabled
Interface BC AUX Port
No Parity
Primary Bit Even Parity
Odd Parity
1 Stop Bit
Stop Bits
2 Stop Bits
5 Data Bits
6 Data Bits
Data Bits
7 Data Bits
8 Data Bits
1200 Baud
2400 Baud
4800 Baud
Baud rate
9600 Baud
19200 Baud
38400 Baud
6.4.26

Platform Trust Technology Submenu

Feature Options
Enabled
fTPM
Disabled
Description
I2C
Select the relay interface to which the
SMBus
POST code will be redirected.
Set the Address for the primary debug
128
port. The standard address value is 0x80.
However, any multiple of 8 is valid for a
primary debug port address, i.e., the low
three bits muse be zero.
0 Above
Specify the I2C/SMBus device Address of,
e.g., a 7-Segment LCD. The factory
226 setting for the SparkFun device is 0xE2.
However, any even device address (bit 0
= 0) can be specified.
Select the interface to be used for the BC
Diagnostic Console output or disable the
BC Diagnostic Console output.
Choose the parity bits for the BC
Diagnostic Console Interface.
Choose the stop bits for the BC Diagnostic
Console Interface.
Choose the data bits for the BC
Diagnostic Console Interface.
Choose the baud rate for the BC
Diagnostic Console Interface.
Description
Enable/Disable fTPM
51
SmartSL User Manual