Graphics Submenu; Intel® Ethernet Connection I210 Submenu - Efco SmartSL User Manual

Feature Options
Fan Speed Setting
6.4.3

Graphics Submenu

Feature Options
Active LFP / EDP
6.4.4
Intel® Ethernet Connection I210 Submenu
Feature Options
NIC Configuration submenu
Blink LEDs 0 - 15
N/A
UEFI Driver
N/A
Adapter PBA
N/A
Chip Type
N/A
PCI Device ID
N/A
Bus: Device: Function
N/A
Link Status
N/A
MAC Address
N/A
Virtual MAC Address
6.4.4.1 NIC Configuration Submenu
Feature Options
Auto Negotiated Specifies the port speed used for the selected
Link Speed
10 Mbps Half
10 Mbps Full
100 Mbps Half
100 Mbps Full
Wake on LAN Disabled
Enabled
Description
0%
10%
25%
40%
Boot up fan speed in percent of the maximum
50%
supported speed
60%
75%
90%
100%
Description
N/A
Description
Configure Boot Protocol, Wake on LAN, Link Speed,
and VLAN.
Identify the physical network port by blinking the
associated LED.
Displays the UEFI Driver version.
Displays the Adapter PBA.
Displays the type of Chip in which the Ethernet
controller is integrated.
Displays the PCI Device ID of the Ethernet controller.
Displays the PCI Bus: Device: Function number of
the Ethernet controller.
Displays the Link Status.
Displays the MAC Address.
Programmatically assignable MAC address for port
Description
boot protocol.
Enables the server to be powered on using an
in-band magic packet.
39
SmartSL User Manual