Msata Socket - Efco SmartSL User Manual

PIN Name
C1 VCC +5 VDC power supply input (optional use by the card)
Reset signal, used to reset the card's communications. Either used
by itself (reset signal supplied from the interface device) or in
C2 RESET combination with an internal reset control circuit (optional use by the
card). If internal reset is implemented, the voltage supply on VCC is
mandatory
Provides the card with a clock signal, from which data
C3 CLOCK
communications timing is derived
C4 RESERVED AUX1, optionally used for USB interfaces and other uses.
C5 GND Ground (reference voltage)
Programing voltage input (optional). This contact may be used to
supply the voltage required to program or to erase the internal non-
volatile memory. ISO/IEC 7816-3:1997 designated this as a
C6 VPP programming voltage: an input for a higher voltage to program
persistent memory (e.g., EEPROM). ISO/IEC 7816-3:2006
designates it SPU, for either standard or proprietary use, as input
and/or output.
Input or Output for serial data (half-duplex) to the integrated circuit
C7 I/O
inside the card.
C8 RESERVED AUX2, optionally used for USB interfaces and other uses.

3.5.3 mSATA socket

The SmartSL supports one mSATA SSD socket.
SmartSL User Manual
Description
22