Gigabit Ethernet Port - Efco SmartSL User Manual

3.2.4 Gigabit Ethernet Port

The SmartSL offers two Gigabit Ethernet (GbE) ports that use Intel
Ethernet controllers. The GbE ports are located on the front panel and will support
Wake-on-LAN function. When you plug in the Ethernet cable, you will see the Ethernet
status and speed from the LED indicators on the RJ45 connector as follows:
1000 Base-T uses all pairs for bidirectional traffic in the RJ45 connector.
Recommended cables to be used are the Category 5e (enhanced).
Active/Link LED
LED Color Status
OFF The Ethernet port is disconnected.
Yellow ON Ethernet port is connected with no data transmission
Blinking Ethernet port is connected, and data is transmitting/receiving
Speed LED
LED Color
Green
Or
Orange
To utilize the GbE port in Windows, you will need to install the corresponding driver for
the Intel® i210 GbE controller.
PIN Name
1 BI_DA+ Bi-directional pair A +
2 BI_DA- Bi-directional pair A -
3 BI_DB+ Bi-directional pair B +
4 BI_DC+ Bi-directional pair C +
5 BI_DC- Bi-directional pair C -
6 BI_DB- Bi-directional pair B -
7 BI_DD+ Bi-directional pair D +
8 BI_DD- Bi-directional pair D -
Description
Status
OFF 10Mbps
Green 100Mbps
Orange 1000Mbps
13
SmartSL User Manual
®
i210 Gigabit
Description
Description