Quectel BG95 Series Hardware Design page 44

The USB interface is recommended to be reserved for firmware upgrade in customers' designs. The
following figure shows a reference circuit of USB interface.
A common mode choke L1 is recommended to be added in series between the module and customer's
MCU in order to suppress EMI spurious transmission. Meanwhile, the 0Ω resistors (R3 and R4) should be
added in series between the module and the test points so as to facilitate debugging, and the resistors are
not mounted by default. In order to ensure the integrity of USB data line signal, L1/R3/R4 components
must be placed close to the module, and also these resistors should be placed close to each other. The
extra stubs of trace must be as short as possible.
The following principles should be complied with when design the USB interface, so as to meet USB 2.0
specification.
 It is important to route the USB signal traces as differential pairs with total grounding. The impedance
of USB differential trace is 90Ω.
 Do not route signal traces under crystals, oscillators, magnetic devices and RF signal traces. It is
important to route the USB differential traces in inner-layer with ground shielding on not only upper
and lower layers but also right and left sides.
 Pay attention to the influence of junction capacitance of ESD protection components on USB data
lines. Typically, the capacitance value should be less than 2pF.
 Keep the ESD protection components as close to the USB connector as possible.
NOTE
BG95 module can only be used as a slave device.
BG95_Hardware_Design
Figure 15: Reference Circuit of USB Interface
LPWA Module Series
BG95 Hardware Design
43 / 80