Table of Contents
Advertisement
I
NSTALLATION
2.4
Mounting the unit
x
b
12
7. Perform the following settings on the control panel to
adjust the operation of the comfort air curtain to the sys-
tem (section 4):
-
if external controllers are used: the functions of the inputs
and outputs (function nos. 52, 60, 61 and, possibly, 76
at the installer's level, see section 4.5);
-
if long-life filters are used: the filter life (function no. 3 at
the installer's level, see section 4.3);
-
other functions at the installer and/or manager's level
(as needed).
General instructions
Some parts of this section are applicable only to certain
models. Where this is the case, it will be indicated. If no spe-
cific model is referred to, the description applies to all models.
n
Note:
Make sure you perform all installation operations that are
required for your unit.
Check the type plate. Refer to section
sure about the model or type of your unit.
n
Note:
Protect the unit from damage and ingress of dust, cement,
etc. throughout the installation. You can, for instance, use
the packaging for protection.
2.4.1 Positioning the unit
•
Make sure that the structure from which the unit is about
to be suspended can bear the weight of the unit. The
weight is specified on the type plate (see section 1.3.4).
•
Note the following dimensions:
-
The unit must be at least as wide as the doorway
(dimension b).
-
Position the unit as near to the doorway as possible.
-
The maximum mounting height of the unit (dimension
h
h, measured from the floor to the discharge grille)
depends on the unit type and circumstances. If not
sure, ask Biddle for advice on the correct height.
C
A
C
OMFORT
IR
URTAIN
1.3.3
if you are not
Advertisement
Table of Contents
