Finishing The Unit - Biddle CA Series User's And Installer's Manual

I
NSTALLATION
2.8

Finishing the unit

2
1
22
2.7.5 Connecting external controls to unit (optional)
The terminals are located in the connector plate on the top of
the unit. The corresponding connectors are located in the ter-
minals.
4
• Connect the output signal cable to terminal 3.
3
• Connect the input signal cable to terminal 4.
n
Note:
Allow some 30 cm excess cable length: it will be needed to
take the electronics out when servicing the unit.
2.8.1 Finishing free-hanging models
Fitting end panels
1. Fit the end panels to either side of the unit:
-
-
If linking two or more units to each other, fit the end
panels to the outer ends.
Fitting inlet grates
2. Fit the inlet grates to the unit:
-
-
3
2.8.2 Finishing recessed models
General
n
Note:
Ensure that the unit remains accessible for maintenance
and repair through, for instance, an inspection hatch.
Hook the end panels 1 into the key holes in side 2.
Push the panels down until you hear a click.
Hook the grates onto the upper side of the unit.
The back of each grate has a projection. Fit the grate
with the projection into the rectangular hole 3.
C A C
OMFORT IR URTAIN