Table of Contents
Advertisement
U
'
I
'
M
SER
S AND
NSTALLER
S
6.3
Fault messages in control panel
fault code
indication: fault
still present
Version: 4.0 (23-08-2007)
ANUAL
n
6.3.1 Reading faults
Current faults
If the message
appears in the display, there is a fault.
Next to it, the fault code is displayed.
The fault code will disappear when you press any key. The
message
will however remain visible as long as the
fault is not corrected.
There may be more than one fault at the same time. You can
read out a list of current fault codes at the manager's level (see
section 4.2.3, function no. 10).
No-longer-current faults
If a fault occurred in your absence but has been automatically
cleared in the meantime, only the fault code is displayed. It will
disappear when you press any key.
At the installer's level, you can read out the codes and times of
the last five faults (see section 4.2.3, function nos. 91 to 95).
6.3.2 Deleting faults
Most fault messages will disappear automatically when the
problem is resolved. However, some faults must be manually
removed by deleting the fault message at the manager's level
(see section 4.2.3, function no. 10).
6.3.3 Resetting control panel
Some faults may be corrected by resetting the control panel at
the installer's level: the panel will then look again for con-
nected units (see section 4.3.3, function no. 71 or 98).
Note:
This will default all settings at the installer's level. Write
down your settings in advance, and re-enter them after the
reset.
F
AULTS
47
Advertisement
Table of Contents
