Warnings And Recommendations - Wilson Electronics 271245 Installation Manual

Mobile wireless dual-band cellular / pcs amplifier
Hide thumbs Also See for 271245:
Table of Contents

Advertisement

Warnings and Recommendations

Warning:
In a wireless installation, do not plug the amplifi er directly into
the cell phone or cellular data card using an antenna adapter. It
will damage the cell phone or cellular data card.
Warning:
Do not plug in the DC power supply until the outside and inside
antenna cables are attached to the amplifi er.
Warning:
RF Safety: The inside antenna must be installed with a
separation of at least eight inches from all persons and must not
be located in conjunction with any other antenna or amplifi er.
Warning:
RF Safety: The outside antenna must be installed with a
separation of at least 10 inches from any of the vehicle's
occupants or nearby persons and must not be located or
operating in conjunction with any other antenna or amplifi er. All
roof-mount antennas should be centrally located on the roof of
the vehicle. Mirror-mount antennas should be at least six inches
from the ground and leave at least 20 inches of separation from
any persons near or around the vehicle. Use of this cellular
amplifi er with an antenna gain higher than 6.12 dBi is in violation
of FCC regulations for which the offender is fully liable. All
Wilson mobile antennas are 6.12 dBi or less.
Separation of inside and outside antennas is very important. The metal
roof of the vehicle acts as a barrier and helps shield the two antennas from
each other, preventing oscillation.
If the vehicle has a sunroof, it is important to separate the inside and outside antennas
by at least fi ve feet. This prevents the amplifi er from overloading or oscillating.
Distance between antennas
through a sunroof must be
5 feet or more.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents