Warnings And Recommendations - Wilson Electronics SignalBoost Installation Manual

Warnings and Recommendations

Warning:
Warning:
Warning:
Recommended amplifier installation locations for a vehicle are:
• Under the seat
• Under the dash
Power the amplifier through the ignition switch so the amplifier is turned on and
off with the vehicle.
Recommended amplifier installation locations for a home or office are:
• on a desk or table top
• in a bookshelf
• On the floor
 
Do not plug the amplifier directly into the cell phone or cellular
data card using an antenna adapter. it will damage the cell
phone or cellular data card.
Do not plug in the power supply until the antenna other cables
are attached to the amplifier.
RF Safety: Vehicle and indoor building antennas must be
installed with a separation of at least 8 inches from all persons.
Fixed outdoor building antennas must be installed with a
separation distance of at least 24 inches from all persons. These
antennas must not be located or operating in conjunction with
any other antenna or amplifier.
notE: Use of this amplifier with an antenna gain higher than
6.12 dBi on a vehicle or within a building is in violation of FCC
regulations. All Wilson mobile antennas have 6.12 dBi or less
gain. Use of this amplifier with an outside building antenna gain
exceeding 15 dBi is in violation of FCC regulations. All Wilson
Yagi antennas have gains of 15 dBi or less. Use of antennas
with higher than the above maximum allowable gains is in
violation of FCC regulations for which the offender is fully liable.