WAREMA WMS WebControl Manual page 24

Settings - control modes
24
We reserve the right to make technical changes
Control modes in the "Operation" menu
 enable
You have set the control modes for a channel in a room to "Off" (slider in
Fig. 17) and have enabled these for a switching time (Fig. 18). This means
that the values entered for the switching time always apply at that time and
the sun shading system moves to this position at that time. Control modes
do not apply at this switching time.
 disable
You have set the control modes for a channel in a room to "Off" (slider in
Fig. 17) and have disabled these for a switching time (Fig. 18). This means
that the values entered for the switching time always apply at that time and
the sun shading system moves to this position at that time.
Control modes do not apply at this switching time.
 unchanged (- -)
You have set the control modes for a channel in a room to "Off" (slider in
Fig. 17) and have disabled these for a switching time (Fig. 18). This means
that the values entered for the switching time always apply at that time and
the sun shading system moves to this position at that time. Control modes
do not apply at this switching time.
 enable
You have set the control modes for a channel in a room to a certain bright-
ness value (e.g. 25 klx) using the slider (Fig. 17) and have enabled these
for a switching time (Fig. 18). This means that the values entered for the
switching time apply and the sun shading system moves to this position at
that time. When the brightness value set in the control mode is reached, the
control mode takes over control of the sun shading system.
 disable
You have set the control modes for a channel in a room to a certain bright-
ness value (e.g. 25 klx) using the slider (Fig. 17) and have disabled these
for a switching time (Fig. 18). This means that the values entered for the
switching time apply. The control mode is deactivated until it is switched on
again (i.e. enabled for this switching time).
 unchanged (- -)
You have set the control modes for a channel in a room to a certain bright-
ness value (e.g. 25 klx) using the slider (Fig. 17) and have set these to
unchanged (- -) for a switching time (Fig. 18). This means that the values
entered for the switching time apply. The control function set via the slider
applies when the set value is reached.
An overview is also provided in the table in the appendix (see Chapter 14 on
page 41).
WMS WebControl
(see Fig. 16)
2004919_i•en•2017-09-01