Figure 5: Share2: 15 Wire Harness
Two-station wiring for Share2 (15 Wire Harness)
HCS #1
15 Wire
Harness
HCS #1
15 Wire
Harness
Verify Share2 Function is Working Properly
After wiring is complete use a DC volt meter to test functionality.
Connect the volt meter negative lead to ground, then connect the
volt meter positive lead to the White/BK wire. A measurement
greater than 4V DC should be seen when a vehicle is not connected
or not charging. A voltage less than 1V DC will be measured on the
White/BK wire when a vehicle is charging.
NOTE: There is a 5 second delay once one vehicle stops
charging before the White/BK wire returns to greater than
4V DC and an additional 10 seconds before full circuit
power will be available to the other vehicle.
HCS Optional Features User Manual
15 Wire Harness Simplified
15
HCS #2
15 Wire
Harness
HCS #2
15 Wire
Harness