Bosch Professional GLM 50 C Original Instructions Manual page 17

Move the measuring tool until the required distance is shown at the bottom of the dis-
play.
Briefly pressing the measuring button (2) [ ] will interrupt the con-
tinuous measurement. The current measured value will be shown at
1.291 m
min
the bottom of the display. The maximum and minimum measured
-64°
11.623 m
max
value appear above it. Pressing the measuring button (2) [ ] once
more will start the continuous measurement again.
11.623 m
Continuous measurement automatically switches off after
five minutes.
Area measurement
Select the area measurement mode
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance to be
measured flashes in the indicator for area measurement
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area will be
automatically calculated and displayed. The end result is shown at
0.0°
3.810 m
the bottom of the display, while the individual measured values are
5.080 m
2 shown above it.
19.355 m
Volume measurement
Select the volume measurement mode
Then measure the width, length and depth one after the other as with a length measure-
ment. The laser beam remains switched on between the three measurements. The dis-
tance to be measured flashes in the indicator for volume measurement
The first measured value is shown at the top of the display.
After the third measurement has been completed, the volume will be
10.160 m
automatically calculated and displayed. The end result is shown at
0.0°
11.430 m
the bottom of the display, while the individual measured values are
12.700 m
3 shown above it.
1474.8 m
Indirect distance measurement
For indirect length measurements, three measuring modes are available. Each measur-
ing function can be used for determining different distances.
The indirect distance measurement is used to determine distances that cannot be meas-
ured directly, due to an obstacle that would impede the path beam or the absence of a
Bosch Power Tools
.
.
.
1 609 92A 5E3 | (30.03.2020)
English | 17
.