Bosch Professional GLM 50 C Original Instructions Manual page 19

Once the measurement is complete, the result for the required dis-
tance X is displayed in the result row (e). The measured values for
20.000 m
distance 1 and angle α can be found in the measured value row (d).
60°
60.0°
10.000 m
Wall area measurement (see figure E)
The wall area measurement is used to determine the sum of multiple individual areas
with a common height. In the illustrated example, the total area of several walls that have
the same ceiling height H but different lengths L is to be determined.
Select the wall area measurement mode
Measure the ceiling height H as for a length measurement. The measured value is dis-
played in the top measured-value line. The laser remains switched on.
Then measure the length L
calculated and displayed in the result line (e). The last measured
1.291 m
H
value for length can be found in the bottom measured value line (d).
0.0°
2.583 m
L
The laser remains switched on.
2.583 m
L
2
3.336 m Now measure the length L
ured value displayed in the measured value line (d) is added to the
length L . The sum of the two lengths (displayed in the middle measured value line (d)) is
1
multiplied by the saved height H. The total area value is displayed in the result line (e).
You can measure any number of lengths L
plied by the height H. The requirement for a correct area calculation is that the first
measured length (for example the ceiling height H) is identical for all sub-areas.
Stake out function (see figure F)
The stake out function repeatedly measures a defined length (distance). These lengths
can be transferred to a surface, for example to enable material to be cut into pieces of
equal length or to install stud walls in a drywall construction. The minimum adjustable
length is 0.1 m and the maximum length is 50 m.
Note: The distance from the marking is shown in the display in the stake out function.
The reference is not the edge of the measuring tool.
Select the stake out function .
Set the required length. Select the corresponding digit/position with the (7) [Func] but-
ton and change the value with the (3) [+] or (8) [–] button.
Begin the stake out function by pressing the measuring button (2) [ ] and slowly move
away from the starting point.
Bosch Power Tools
.
of the first wall. The area is automatically
1
of the second wall. The individual meas-
2
, which will be automatically added and multi-
x
1 609 92A 5E3 | (30.03.2020)
English | 19