Bosch Professional GLM 50 C Original Instructions Manual page 16

16 | English
– The front edge of the measuring tool (e.g. when measuring from a table edge)
– The centre of the thread (13) (e.g. for tripod measurements)
To select the reference level, press the button (4). Use the [+] button (3) or the [–] but-
ton (8) or the button (4) to select the required reference level. The rear edge of the
measuring tool is preset as the reference level every time the measuring tool is switched
on.
Basic settings menu
To enter the basic settings menu (i), press and hold the [Func] button (7).
Select the respective basic setting and choose your setting.
To exit the basic settings menu, press the on/off button (5) [ ].
Display illumination
The display illumination is continuously switched on. When no button is pressed, the dis-
play illumination is dimmed after approx. 20 seconds to preserve the batteries.
Measuring functions
Measuring length
Select the length measurement mode
To switch on the laser beam, briefly press the measuring button (2) [ ].
To measure, briefly press the measuring button (2) [ ]. The measured value will be
shown at the bottom of the display.
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
7.620 m
ured value is above it, and so on.
0.0°
8.890 m
10.160 m
11.430 m
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated every half a second. You can, for
example, move a required distance away from a wall while reading off the current dis-
tance at all times.
Select the continuous measurement mode
To switch on the laser beam, briefly press the measuring button (2) [ ].
1 609 92A 5E3 | (30.03.2020)
.
.
Bosch Power Tools