Install The Cables - Kaba PowerLever 1550 Installation Manual

Install the Cables

Warning: Do not remove the shield. This
could cause damage to the system
card.
Warning: Ensure that the solenoid cable is
routed to the inside of the PEM nuts
used for mounting the inside case. The
solenoid cable will exit either the left or
right hole in the backing plate depend-
ing on the latchbolt position.
Note: Refer to Figure 15.
1. Plug the system cable into the system
card.
2. Route the solenoid cable through the
cable clip.
3. Plug the solenoid cable into the 2-pin
connector on the system card.
4. If installing a Model 45xx or PowerLever
PROX 9000 lock, you must also connect
the communication cable to the system
card. Plug the communication cable into
the appropriate connector on the bottom
edge of the system card, as shown in the
photo.
Installation
14
Figure 15
Solenoid Cable
Connector
Communication
Cable Connector
Document Number 481.093 Rev. A - 06/04
SW2 - Factory
Reset Switch
System Cable
Connector