Page 1
Access Control - 1000 Series PBL FAQ Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may be a ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting procedures outlined at bottom of this document for a zero code symptom/solution.
Page 2
Access Control - 1000 Series PBL FAQ 1. Insert the DF-59 control key (B) into the combination change plug assembly (C) and unscrew the cylinder by turning the key counterclockwise. Remove the combination change plug to gain access to the combination change sleeve (D) (see figure 1).
Page 3
Access Control - 1000 Series PBL FAQ Cause: Lock is in zero combination. Solution: Follow the procedure for changing a combination except omit step 3 (do not enter the existing combination). PRINT THIS SECTION PREVIOUS PAGE http://www.kaba-ilco.com/access_control/support/pbl_faq/changing_code_combination/1000_series.asp (3 of 3) [5/21/2004 11:13:59 AM]...