Install The Inside Backing Plate/Electronics Assembly - Kaba PowerLever 1550 Installation Manual

3. From the outside of the door, feed the solenoid cable through the 2 1/8" (54mm) hole.
Caution: Ensure that the solenoid cable does not get tangled in the latchbolt mechanism.
4. From the outside of the door, feed the system cable and
communication cable (if applicable) through the 1"
(25.4mm) hole.
5. Insert the chassis assembly into the hole. Be sure that
the chassis assembly engages the latch prongs and that
the latch tail engages the retractor as shown in Figure
11.
Caution: Ensure that the solenoid cable does not get tangled
in the latchbolt mechanism.

Install the Inside Backing Plate/Electronics Assembly

1. If your lock includes outdoor gaskets, you should
at this time install the Inside Gasket. Refer to
Figure 12 and identify the Inside Backing Plate/
Electronics Assembly and Inside Gasket. Re-
move the paper backing sheet from the adhesive
on the Inside Gasket. Position the gasket, with
the adhesive side toward the inside backing plate,
so that the large hole in the gasket is centered
over the four protrusions on the backing plate.
Ensure that the four corner holes in the gasket
are aligned with the matching four corner holes in
the backing plate. When properly installed, the
gasket will overhang the backing plate an equal
amount on all four sides. Once the proper position
of the gasket is verified, press the gasket firmly
into place.
2. Guide the solenoid cable through the hole in the backing
plate. Refer to Figure 13.
Note:The phantom cable indicated in the drawing is the
routing path of the solenoid cable for opposite handing.
3. Guide the system cable (and communication cable if
applicable) through the rectangular hole in the backing
plate.
12 Installation
Figure 11
Figure 12
Figure 13
Document Number 481.093 Rev. A - 06/04