Table of Contents
Advertisement
Syn248 Installation and Configuration Guide
Setting Intercom Call Forward–No Answer
Intercom Call Forward–No Answer is an administrator setting to handle unanswered
Intercom calls for each Deskset, including outside calls that have been routed to a
Deskset by a Phone Line Call Forward–No Answer setting. See
CFNA" on page
By default, Intercom calls are forwarded to Voicemail after they ring for 15 seconds. You
can change the target destination to another extension or to an outside phone number,
or you can turn off call forwarding when there is no answer. You can adjust the delay
from 5 to 45 seconds.
Calls forwarded to outside lines use two telephone lines. You can limit the
duration of calls forwarded to outside lines with the Timer for Forwarded and
Transferred Outside Calls setting. See
on page 30.
You can also disable Fwd / Trans to Outside Line individually for each
extension. See
Outside Line is disabled, you cannot change the target destination to an
outside phone number.
To set up Intercom Call Forward–No Answer:
1. On the Admin Settings menu, press 1 to display the Intercom CFNA settings.
IQtercom CFNA
7DUJHW
'HOD\
Save
2. Press
Mailbox.
Ext. Then press
Phone#. Then press
this setting, "Fwd/Trans to Outside Line" must be enabled.
OFF. Calls will not be forwarded. Go to Step 5.
3. Press
4. Press
5. Press
Device Configuration
41.
"Fwd/Trans to Outside Line" on page 80.
0DLOER[
>VHF@
or
to select a target:
and enter a valid extension in the to Ext: field.
and enter a valid phone number. Before you can save
to highlight the Delay before forwarding.
or
to adjust the delay time in five-second increments.
to accept the change and display the Admin Settings menu.
Save
79
Back to Contents
"Configuring Phone Line
"Changing the System Basic Settings"
If Fwd / Trans to
Advertisement
Table of Contents
Troubleshooting
