Table of Contents
Advertisement
MOUNTING THE SENSOR
Directly to Ceiling
1. Attach the plastic spring clips to
the edge of the sensor in the slots
provided.
2. Cut a 3.5" to 4" round hole in
the acoustic ceiling tile at the
mounting location. A 3.5" hole is
recommended for a secure fit.
3. Pull the low voltage wire from the
power pack to the sensor through
the hole.
4. Connect the low voltage wires to
the appropriate terminals on the
sensor.
5. Push the sensor up through the
hole until the Spring Clips hold the
sensor securely in place.
6. Snap the front cover onto the
sensor.
Using an Octagonal J-Box
1. Pull the low voltage wires from the
power pack into the J-Box through the
conduit knockout.
2. Connect the low voltage wires to the
appropriate terminals on the sensor.
3. Loosen the appliance mounting screws
attached to the J-Box
4. Align the sensor in the J-Box so that
the mounting screws on the box match
the key holes on the sensor's rear
housing.
5. Push the sensor up into the J -Box and
twist it so that the mounting screws are
seated in the keyhole slots.
6. Tighten the two screws to secure the sensor to the J-Box.
7. Snap the front cover onto the sensor.
Visit our website for FAQs: www.wattstopper.com
Ceiling Mount
Ceiling Mount
J-Box Mount
Ceiling
Depluggable terminal
Spring clips (2)
Rear
housing
Front
cover
4" Octagonal J-Box
(at least 1.5" deep)
Ceiling
Depluggable
Terminal
Rear
Housing
Screws
Front
Cover
Advertisement
Table of Contents
