Mounting The Sensor - wattstopper DT-300 Installation Instructions Manual

MOUNTING THE SENSOR

Directly to Ceiling
1. Attach the plastic spring clips to
the edge of the sensor in the slots
provided.
2. Cut a 3.5" to 4" round hole in
the acoustic ceiling tile at the
mounting location. A 3.5" hole is
recommended for a secure fi t.
3. Pull the low voltage wire from the
power pack to the sensor through
the hole.
4. Connect the low voltage wires to
the appropriate terminals on the
sensor.
5. Push the sensor up through the hole until the Spring Clips hold the sensor
securely in place.
6. Snap the front cover onto the sensor.
Using an Octagonal J-Box
1. Pull the low voltage wires
from the power pack into the
J-Box through the conduit
knockout.
2. Connect the low voltage wires
to the appropriate terminals
on the sensor.
3. Loosen the appliance
mounting screws attached to
the J-Box
4. Align the sensor in the J-Box
so that the mounting screws
on the box match the key
holes on the sensor's rear
housing.
5. Push the sensor up into the J -Box and twist it so that the mounting screws are
seated in the keyhole slots.
6. Tighten the two screws to secure the sensor to the J-Box.
7. Snap the front cover onto the sensor.
Call 800.879.8585 for Technical Support
Depluggable terminal
Spring clips (2)
Rear
housing
Front
cover
Ceiling Mount
4" Octagonal J-Box
(at least 1.5" deep)
Depluggable
terminal
Rear
housing
Screws
Front
cover
J-Box Mount
Ceiling
Ceiling