Mounting The Sensor - wattstopper CI-355 Installation Instructions Manual

MOUNTING THE SENSOR

Using a 4-Inch Square Junction
Box with Double-Gang Mudring
1. Pull the high voltage wires into
the J-Box through the conduit
knockout.
2. Connect the high voltage wires to
the appropriate terminals on the
sensor.
3. Align the sensor in the J-Box
so that the mudring mounting
screw tabs on the box match the
mudring mounting holes on the
sensor's rear housing.
4. Use two machine screws
(included with the sensor) to
attach the sensor to the mounting tabs on the J-Box.
5. Snap the front cover onto the sensor.
Using an Octagonal Junction Box
1. Pull the high voltage wires into
the J-Box through the conduit
knockout.
2. Connect the high voltage wires to
the appropriate terminals on the
sensor.
3. Align the sensor in the J-Box so
that the mounting screw tabs on
the box match the key holes on the
sensor's rear housing.
4. Use two machine screws (included
with the J-Box) to attach the
sensor to the mounting tabs on the
J-Box.
5. Snap the front cover onto the sensor.
Visit our website for FAQs: www.wattstopper.com
Mounting to a 4" Square Junction Box with
Mounting to an Octagonal Junction Box
*
The Junction Box must be at
least 2.25" deep. If it is not, an
extension ring is required.
4" Square, 2.25" Deep
Junction Box with
Double Gang
Mudring attached
Drop Ceiling
CA-1 Adapter
Rear Housing
Sensor Flange
Screws
Front
Cover
Mudring
4" Octagonal, 2.25" Deep
Junction Box
Ceiling
Sensor
Screws
Front
Cover
*
*