Table of Contents
Advertisement
WIRING DIRECTIONS
Each WattStopper BZ series power pack
can supply power for 14 CI-305 sensors.
When using more sensors than this,
multiple power packs are required.
Refer to the wiring diagram on the next
page for the following procedures:
Connect the low voltage:
• RED wire (+24VDC) from power pack to
the +24V terminal on the sensor.
• BLACK wire (Return) from power pack
to Common terminal on the sensor.
• B LUE wire from power pack to Control
Out terminal on sensor.
To add a MANUAL SWITCH such as the
LVS-1 Momentary Toggle Switch, or RS2-3 Low Voltage Momentary Switch to the
above applications–connect:
• Wire from one side of switch to +24 terminal on sensor.
• Wire from other side of switch to Man Switch terminal on sensor.
Turn power off at the circuit breaker before
installing power packs or sensors.
Call 800.879.8585 for Technical Support
CAUTION
CI-305
03083r2
v3
Passive Infrared
Occupancy Sensor
LISTED
88T9
+24VDC/VAC
Appliance
Connect to Watt Stopper
Control
Class 2 Power Packs
For Indoor Use Only
Control Out.
U.S.Patents:
5,640,113
Patent Pending
Man. Switch
+24V
Common
www.wattstopper.com
800.879.8585
Wiring
terminals
Advertisement
Table of Contents
