Regency City Series Owners & Installation Manual page 69

CITY LINE
8. Place the split end of Log 3 to the right front corner of the burner—angle
the log so that the other end is sitting approximately 13mm from the
edge of the burner tray.
3
Log 3 placement
9. Place Log 6 and Log 7 on the burner locations shown below.
10. Before placing the next log—spread the optional media evenly
throughout the burner tray as shown.
6
NOTE: Ensure the installed optional media doesn't completely block
the air fl ow—ensure more than 50% of the airfl ow is open (shown with
19mm crushed black glass).
Do not completely
block air fl ow
11. Place Log 4—identify the pin locator and match with the left side
pin on Log 1.
4
920-114
Log to corner of
burner
19mm crushed
black glass
7
Pin in Log 1
Rest the other end of Log 4 on the indent in Log 2 as shown below.
4
2
12. Place Log 5—identify the pin locator and match with the right side
pin on Log 1.
Pin in Log 1
1
Rest the other end of Log 5 on the indent in Log 3 as shown below.
Add lava rock sparsely around the perimeter of the burner.
2
installation
Indent Log 2
5
3
5
Completed Install
City Series ACC40E | 69
06.05.19