Regency City Series Owners & Installation Manual page 32

installation
3. Install B to the side of the unit, use the holes corresponding with the
appropriate shape (diamond or square depending on which unit you
have) using the diagrams below. Attach B to the side of the unit and
install 2 screws in locations shown below.
CC40RE
Holes next to squares
4. Install 2 x part C's onto parts A & B respectively, identify the holes to
be used, attach to the unit with 2 screws each.
C
32 | City Series ACC40E
919-773a
CC40LE
Holes next to diamonds
B
5. Slide unit against wall and line up part C's with studs in the wall.
Attach both part C's to studs with at least two screws each; one at
the top, and one near the unit (as seen below).
6. Install venting before proceeding further with framing kit construction.
Refer to manual for venting instructions.
7. Identify D, attach to back corner C with 2 screws as shown below.
Part D Profi le
C
8. Identify E (see diagram below), attach E to front corner C with 2 screws
as shown below.
Part E Profi le
2
CITY SERIES
Studs
D
E
04.24.17