Advertisement
M68ICS08AB
Pin #
Label
1
RST*
3.3
CONNECTING TO THE IN-CIRCUIT SIMULATOR
Using the 16-pin cable provided with the ABICS kit, connect one end of the
cable to the ABICS board at P5. Connect the other end to connector P1 on the
target system board. The pin-1 indicators on each cable end must correspond to
the pin-1 indicators on the headers. P2 is not used when connecting to the
ABICS board.
M68ICS08ABUM/D
Table 3-2. MON08 Target System Connector P2
Direction
bi-directional
Connect to MCU RST* pin and P2 pin 4. No other target
system logic should be tied to this signal. It will swing
from 0 to +7.5 Vdc.
15
Figure 3-1. MON08 Target System Connector Layout
CHAPTER 3 – USING THE MON08 INTERFACE
Target System Connection
P2
1
2
16
P1
3-3
Advertisement
