Advertisement
2.1
OVERVIEW
This chapter explains how to:
•
•
In interactive mode, the ABICS is connected to the serial port of a host PC.
The actual inputs and outputs of a target system can be used during simulation
of source code.
In stand-alone mode, the ABICS is not connected to the PC. The ICS08ABW
software can be used as a stand-alone simulator. Refer to the M68ICS08AB
IN-CIRCUIT SIMULATOR SOFTWARE OPERATOR'S MANUAL for
detailed information.
Warning: ELECTROSTATIC DISCHARGE PRECAUTION
M68ICS08ABUM/D
CHAPTER 2
HARDWARE INSTALLATION
Configure the M68ICS08AB in-circuit simulator board
Connect the board to a target system
Ordinary amounts of static electricity from your clothing or work
environment can damage or degrade electronic devices and
equipment. For example, the electronic components installed on the
printed circuit board is extremely sensitive to electrostatic
discharge (ESD). Wear a grounding wrist strap whenever handling
any printed circuit board. This strap provides a conductive path for
safely discharging static electricity to ground.
2-1
Advertisement
