Advertisement
CHAPTER 3 – USING THE MON08 INTERFACE
3.4
DISABLING THE TARGET-SYSTEM INTERFACE
To use the target system in a stand-alone fashion (without the ABICS board
connected), jumper the pins on the target board's connectors, as shown in
Figure 3-2. This reconnects the target MCU to the appropriate circuits on the
target system.
For production boards, a further enhancement of this scheme would be to
include cutable traces between the pins of P1 and P2, as shown in Figure 3-2.
The traces may be cut when debugging is necessary. To return the board to
stand-alone use, jumpers may be installed as shown.
3-4
1
15
Figure 3-2. Target System Stand-Alone Connection
P2
2
16
P1
M68ICS08ABUM/D
Advertisement
