Advertisement
Pin
1
2
•
•
2.3
INSTALLING THE HARDWARE
Before beginning, locate these items:
•
•
To prepare the ABICS for use with a host PC:
1. Install the MCU into the M68ICS08AB board.
2. Connect the board to the host PC.
3. Apply power to the board.
2.4
CONNECTING TO A TARGET SYSTEM
The two ways to connect the M68ICS08AB simulator board to a target system
are:
M68ICS08ABUM/D
Table 2-3. W5 Configuration Header – Oscillator Source
Direction
Signal Name
out
SP_OSC
in or out
OSC1
Jumper on pins 1 and 2
Default. The M68ICS08AB oscillator is selected.
Jumper off
Allows using an oscillator on the target system or injecting a different
clock rate at P6 pin 2.
9-pin RS-232 serial connector on the board, labeled P2
5-volt circular power-input connector on the ABICS
Locate the socket XU1 on the board.
Install the MCU (provided with the ABICS package) into this socket,
observing the pin 1 orientation with the socket's notch. The top (label
side) of the MCU package must be visible when looking at the
component side of the board.
Locate the 9-pin connector labeled P2 on the board. Using the cable
provided, connect it to a serial COM port on the host PC.
Connect the 5-volt power supply to the round connector on the board.
Plug the power supply into an AC power outlet, using one of the
country-specific adapters provided. The ICS PWR LED (Yellow) on
the board should light.
CHAPTER 2 – HARDWARE INSTALLATION
Description
4.9152-MHz M68ICS08AB oscillator output
OSC1 on sockets and target connectors
2-3
Advertisement
