Advertisement
CHAPTER 1 – INTRODUCTION
1.6
HARDWARE QUICK START INSTRUCTIONS
For users experienced in installing Motorola or other development tools, the
following steps provide a quick start installation procedure for the ABICS
hardware and software.
For more complete hardware instructions, refer to CHAPTER 2 –
HARDWARE INSTALLATION.
1. Install the ICS08AB software package by following the instructions
2. Connect the board.
1. Complete the installation by following the steps described in Section
If you experience problems with the quick start procedures, refer to
APPENDIX A TECHNICAL REFERENCE & TROUBLESHOOTING
for troubleshooting instructions.
1.7
CUSTOMER SUPPORT
To obtain information about technical support or ordering parts, call the
Motorola help desk at 800-521-6274.
1-18
described in Section 1.5 SOFTWARE QUICK START INSTRUC-
TIONS of the M68ICS08AB IN-CIRCUIT SIMULATOR SOFT-
WARE OPERATOR'S MANUAL.
a. Install the MCU into the M68ICS08AB board.
Locate socket XU1 on the board. Install the MCU (provided with
the M68ICS08AB package) into this socket, observing the pin 1
orientation with the socket's notch. The top (label side) of the MCU
package must be visible when looking at the component side of the
ABICS board.
b. Connect the ABICS to the host PC.
Locate the 9-pin connector labeled P2 on the ABICS. Using the
cable provided, connect it to a serial COM port on the host PC.
c. Apply power to the ABICS.
Connect the 5-V power supply to the round connector on the
ABICS. Plug the power supply into an AC power outlet, using one
of the country-specific adapters provided. The SYSTEM POWER
LED on the ABICS should light.
1.5 SOFTWARE QUICK START INSTRUCTIONS of the
M68ICS08AB IN-CIRCUIT SIMULATOR SOFTWARE OPERA-
TOR'S MANUAL.
M68ICS08ABUM/D
Advertisement
