Humminbird MEGA 360 IMAGING Operation Manual page 9

MEGA 360 Status Icon
NOTE: For additional system status, select Home > Settings > Network > System Info.
HELIX Series
You can confirm the MEGA 360 connection by checking the Accessory Test view.
1. Press and hold the VIEW key.
2. Select System > Accessory Test.
Confirm MEGA 360 is shown as Connected. It may take up to one minute for the MEGA 360 to be detected.
Unconnected: If the MEGA 360 icon is listed as Unconnected, check the cable and power connections to confirm they are
secure and powered on. Review the installation guide that was included with your MEGA 360 Imaging Transducer to confirm
it is installed correctly.
Icon Description
Connected/In Water/Pinging: The MEGA 360 is connected, in the water, and pinging.
Connected/In Water/Not Pinging: The MEGA 360 is connected and in the water, but it is
not pinging.
Connected/Out of Water: The MEGA 360 is connected, but the wet indicator is out of the
water.
Connection Lost: The connection to the MEGA 360 was lost.
HELIX Accessory Test
9
GPS + Heading
Sensor listed
as connected
MEGA 360
Imaging listed
as connected
Power On and Confirm Connections