Isolate A Section Of The Sweep; Activate Quick Sweep; Isolate The Sweep Area - Humminbird MEGA 360 IMAGING Operation Manual

Isolate a Section of the Sweep

There are many options to focus on a section of the sweep. You can set the sweep angle and section yourself, from 360 degrees
down to 10 degrees, or you can use a 45 degree preset section, like front, rear, left, and right.

Activate Quick Sweep

Use Quick Sweep to focus quickly on a section of the view. When the Quick Sweep area is set, the full 360 View will continue to
display on-screen, but the sweep will only cover the angle you select.
SOLIX Series
1. Set the 1st Limit: Press and hold the CHECK key.
2. Set the 2nd Limit: Tap the Check in the status bar.
3. Resume the Full 360 Sweep: Tap the Full 360 icon in the
status bar.
Activating Quick Sweep (SOLIX)

Isolate the Sweep Area

Isolating the sweep area allows you to focus the sweep on a section of the water. The sweep area can be set between 10° to 360°,
and you can adjust it as you prefer.
SOLIX Series
1. X-Press Menu: With a 360 View displayed on the screen,
press the MENU key once, or tap Sonar (360) on the
status bar.
2. Select Isolate Sweep Area.
3. The sweep area can be adjusted as follows:
Adjust the Sweep Position: Turn the Rotary Dial.
Adjust the Sweep Size: Use the RIGHT and LEFT Cursor
keys or press and hold to drag the double-sided arrows.
4. Confirm the Selection: Press the CHECK in the status bar.
5. Close: Select Resume Full Sweep from the X-Press Menu.
NOTE: You can quickly return to your isolate sweep
setting by tapping the Isolate Sweep icon in the status
bar.
Isolate Sweep
HELIX Series
1. Set the 1st Limit: Press the CHECK/INFO key.
2. Set the 2nd Limit: Press the CHECK/INFO key.
3. Resume the Full 360 Sweep: Press the CHECK/INFO key.
Activating Quick Sweep (HELIX)
HELIX Series
1. X-Press Menu: With the 360 View or Combo View
displayed on the screen, press the MENU key once.
2. Select Isolate Sweep Area. Press the RIGHT Cursor key.
3. The sweep area can be adjusted as follows:
Adjust the Sweep Position: Press the RIGHT or LEFT
Cursor keys.
Adjust the Sweep Size: Press the UP or DOWN Cursor keys.
4. Confirm the Selection: Press the CHECK/INFO key.
5. Close: Select Resume Full Sweep from the X-Press Menu.
40