Table of Contents
Advertisement
These operations are only necessary the first time you switch on your remote control.
All setups can be modified at any time by accessing the SETTINGS section.
1 - Follow the instructions on page 27 to insert the batteries.
The screen of the remote control will be activated immediately.
ATTENTION! When you replace flat batteries, all the settings and the programming
carried out until the time of replacement will be held in the remote control memory.
The only exception will be the "time and day", which will have to be set when the
remote control is started.
2 - First screen: language selection.
Select the language you require by using the UP/DOWN+SELECT keys and press SAVE.
3 - Second screen: Day & Time setup.
Use the UP/DOWN keys to set the required value.
Press SELECT to move from one box to another within the same screen.
After setup, press SAVE to save the input data.
4 - Third screen: SYSTEM STATUS.
This screen shows the current settings of the remote control. (see next page for further
details).
This is the initial screen you will see when you use the remote control every day. From
this screen you can go on to the navigation. From SYSTEM STATUS you can quickly access
adjustment of the sensor levels (left button), the Main Menu (right button) or manual
control of the solar protection device with the direction buttons (UP, DOWN, STOP).
SENSORS LEVELS
PRELIMINARY OPERATIONS
UP
DOWN
29
STOP
MAIN MENU
Advertisement
Table of Contents
