Setting The "Automatic Disable" Time; Sensors Test - CHERUBINI Skipper Senso Instructions Manual

The factory settings are the following:
Hysteresis: 250
Brightness: 500
Twilight: 20 (min 0 - max = lower hysteresis frame limit)
It is suggested that these values be changed according to the actual levels ascertained by
the sensor inside of the area being controlled.

Setting the "Automatic Disable" time:

In "Automatic" mode it is always possible to manually command the motor. This action
blocks automatic function of the automation for a period of time that may be set by the
user, as follows:
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings

Sensors Test

TEST
Select
Save
Value set at the factory: 0 (the automation is not blocked after a manual command).
The value is in minutes (range: 0-120, in steps of 10 minutes).
Sensors Test:
In this screen the remote control reacts immediately to the sensor threshold steps. It is
therefore possible to check if the Skipper Senso is properly communicating with the motor
it is connected to. To perform the test, go to the "Sensors Test" item on the display and
directly change the threshold values. The values now set will be the new remote control
sensor thresholds.
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings
Sensors Test
TEST
Select
Save
Mar 15:22
PROGRAMMING
Device
Timetable
8:00
Sensors enabling
Hysteresis
h
Season opt.
Select
Mar 15:22
SENSORS TEST
Brightness: 0500
Temperature: 35°C
Regolation
Save
36
B button: to go from one
Mar 15:22
screen to another
TIMETABLE
A-C buttons: to set the
Enable
values desired
:
Start Time 08 00
LFT button: returns to the
:
20 00
End Time
Programming Screen without
saving
Manual Disab. 000
RT button: saves and returns
Select
to the Programming screen
Save
B button: to go from one
screen to another
A-C buttons: to set the
values desired
LFT button: returns to the
Main Menu Screen without
saving
RT button: saves and returns
to the Main Menu Screen