Table of Contents
Advertisement
PROGRAM LOCK
In order to avoid involuntary changes to the programming, it is possible to activate
the "Program Lock" during the daily use of the remote control. When the "Program
Lock" is active, the SELECT key must be kept pressed for 4 seconds in order to make
the PROGRAMMING section accessible from the main menu. Once the lock has been
"released", the PROGRAMMING section normally remains accessible until the next time
you switch the remote control off for a long time.
How to activate/deactivate the lock:
Main menu / Settings / Progamm lock
Move to the desired option using the UP/DOWN keys, then press SELECT + SAVE.
PLEASE NOTE: even with the "program lock" activated it is still possible to access the
quick adjustment of the sensor thresholds from System Status (see page 34).
ATTENTION!
If the Program Lock is active (see Settings on page 38), you must keep the
middle key pressed for 4 seconds in order to make this section accessible.
DEVICE
The Skipper Senso is able to manage a device such as a blind/screen, awning, tilting blind
or venetian blind that will already be created at the moment it is turned on. To enable the
sensor function, it is necessary to memorise the motor on the remote control with one of
the procedures illustrated below.
To change the name of the device set or to change the type (type set: blind), see "Modify
a device " on page 43.
Advisable for daily use!
DEVICE PROGRAMMING
38
Advertisement
Table of Contents
