Table of Contents
Advertisement
ATTENTION! Even if the Skipper Senso remote control can be used for all
installation devices, it is advisable to use also other remote controls (single or
multi-channel ones) in order to control the devices in case of emergency (e.g.
flat batteries). Alternatively, we suggest using a wire remote control (white
wire for Tronic, Wave and Oriens).
Programming the LIMIT-SWITCHES
The limit switches of the stored device can be programmed
using the same sequence of keys as those used for other
Cherubini remote controls. The UP/STOP/DOWN commands
correspond to the A/B/C ones.
How to make the programming accessible:
- Deactivate the "Program Lock" (see SETTINGS, page 38), if it is active.
- Go to the "System Status" screen.
- Press the keys in the necessary sequence according to the instructions for using the
motor.
COMMANDS
- UP/DOWN: to open/close awnings and blinds.
Awning: UP closes and DOWN opens
Blind: UP opens and DOWN closes
Venetian blind: UP opens and DOWN closes
Tilting blind: UP opens and DOWN closes
Tilting blind in tilt area: UP = less light; DOWN = more light
DEVICE: any motor linked with the Skipper Senso remote control. Each device is linked
with a name which can be customized by the customer (e.g. kitchen, bedroom, terrace)
and with a type (blind, awning, etc.) which clearly indicate which element of the house
or of the office they refer to (e.g.: blind-living01 refers to the first of the 2 blinds in the
living room).
LIMIT SWITCHES: When a motor is installed on an awning/blind, the maximum opening
and the maximum closing positions of the awning/blind are set. They are the so-called
"limit switches" and avoid damage to the motor and to the components of the awning/
blind/venetian blind. The opening and closing positions are initially set by the installer
according to your requirements. Generally, it is not necessary to re-set the limit switches.
In case of problems, contact your installer.
INFORMATION FOR THE INSTALLER
GLOSSARY
44
A
B
C
Advertisement
Table of Contents
