CHERUBINI Skipper Senso Instructions Manual page 20

STORING OF OTHER REMOTE CONTROLS
The procedure remains the same in all 3 cases. Only the order in which the remote controls
are used changes. Please refer to the following scheme in order to find the procedure
which meets your requirements:
To add:
LCD
remote control
Another Cherubini
remote control*
LCD
remote control
**Remote control of the Skipper series (not LCD) or Giro series
LEGEND:
Tn/Cn: already stored remote control /channel (not LCD)
Tx/Cx: remote control/channel to be stored (not LCD)
Before using the keys in the given sequence:
- Make sure that the motor or receiver is powered.
- On Skipper Senso go to the "System Status" screen.
- On the Multi-channel remote controls (Skipper series or Giro series) position yourself
on the desired channel.
P 4To add an LCD remote control to a device created with another Cherubini
rocedure
remote control:
A B
Already stored remote control
P 5To add another Cherubini remote control to a device created with an LCD
rocedure
remote control:
A
+ B
Already stored LCD remote control
To another device created using:
Another Cherubini
remote control*
LCD
remote control
(another) LCD
remote control
B
B
42
Procedure:
Tn/Cn
Skipper/Giro
A+B; B
LCDn
LCD
remote control
A+B; B
LCDn
LCD
remote control
A+B; B
LCDx: Device to be stored on a LCD remote control
LCDn: Device already stored on a LCD remote control
B
2sec
LCD remote control to be stored
2sec
Remote control to be stored
LCDx
4
LCD
remote control
B (2 sec)
Tx/Cx
5
Skipper/Giro
B (2 sec)
LCDx
6
LCD
remote control
B (2 sec)
B