Season Option Settings; Adjusting The Brightness Hysteresis Frame And Threshold - CHERUBINI Skipper Senso Instructions Manual

Season Option Settings:

Season Option is managed by the temperature sensor. To set the season desired, do the
following:
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings
Sensors Test
TEST
Select
Save
Value set at the factory: Summer.
For the notes on the operation of the Season Option, see the "Temperature" table on
page 32.

Adjusting the brightness hysteresis frame and threshold:

In the "Sensor Thresholds" screen, only a basic adjustment of the brightness sensor is
possible. For a finer adjustment of the brightness sensor activation values, do as follows:
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings
Sensors Test
TEST
Select
Save
Namely:
- Hysteresis frame: adjust the tolerance range compared to the activation threshold set on
the brightness sensor. If the brightness threshold is adjusted at 500 and the hysteresis
frame at 250, the automation activation threshold value will be 250 (lower threshold)
and 500 (upper threshold);
- Brightness: set the brightness sensor activation threshold, that is to say the maximum
brightness value that is not to be breached in the controlled area;
- Twilight (optional): set the twilight threshold, that is to say, the brightness value in the
evening hour when you want the blinds/venetian blind or awnings to be closed. This is
activated by selecting the "Activation" item in the display.
Mar 15:22
PROGRAMMING
Device
Timetable
8:00
Sensors enabling
Hysteresis
h
Season opt.
Select
Mar 15:22
PROGRAMMING
Device
Timetable
8:00
Sensors enabling
Hysteresis
h
Season opt.
Select
35
A and C buttons: to go from
Mar 15:22
one function list to the next
SEASON OPTION
B button: to enable/disable
Summer
the item desired
Winter
LFT button: returns to the
Programming Screen without
saving
RT button: saves and returns
Select
to the Programming screen
Save
B button: to go from one
Mar 15:22
screen to another
HYSTERESIS/LEVELS
A-C buttons: to set the
Hysteresis: 0250
values desired
Brightness: 0500 LFT button: returns to the
Programming Screen without
Enable
saving
Twilight: 0020
RT button: saves and returns
Regolation
to the Programming screen
Save