Preliminary Operations; Rapid Access Controls - CHERUBINI Skipper LCD Instructions Manual

These operations are only necessary the first time you switch on your remote control. All
setups can be modified at any time by accessing the SETTINGS section.
1 - Follow the instructions on page 24 to insert the batteries.
The screen of the remote control will be activated immediately.
ATTENTION! When you replace flat batteries, all the settings and the programming
carried out until the time of replacement will be held in the remote control memory.
The only exception will be the "time and day", which will have to be set when the
remote control is started.
2 - First screen: language selection
Select the language you require by using the UP/DOWN+SELECT keys and press SAVE.
3 - Second screen: Day & Time setup
Use the UP/DOWN keys to set the required value.
Press SELECT to move from one box to another within the same screen.
After setup, press SAVE to save the input data.
4 - Third screen: SYSTEM STATUS
This screen shows the current settings of the remote control. (see AUTOMATION, page 36,
for further details).
This is the initial screen you will see when you use the remote control every day. From
this screen you can go on to the navigation. From SYSTEM STATUS you can quickly access
four different menus by using the arrow keys or you can reach the main menu directly by
pressing the middle key.

Rapid access controls

Before programming Devices, Groups and Scenarios, the related rapid access controls will
be inactive. If the PROGRAM LOCK (see page 28) is active, the Automation section will
not be accessible.

PRELIMINARY OPERATIONS

SCENARIOS
AUTOMATION
DEVICES
MAIN MENU
GROUPS
25