Operational Modes; Setting The Operational Mode; System Status "Manual; System Status"Automatic - CHERUBINI Skipper Senso Instructions Manual

Each time the display is activated, the currently set operational mode is indicated on the
SYSTEM STATUS screen. Two operational modes are available:
- Manual
- Automatic
When the remote control is turned on for the first time it is set to manual mode.

Setting the Operational Mode

To change the Operational Mode, perform the following steps from the Main Menu:
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings
Sensors Test
TEST
Select
Save
Select the item desired and save.
System status - MANUAL
In MANUAL mode, motor management by the brightness and temperature sensors is
deactivated. In this mode, the sensors, if enabled, will in any case show the brightness and
temperature levels in the room, but these do not control motor movement for exceeding
the thresholds.
It is possible to control the motor with just the UP/DOWN/STOP buttons on the remote
control.
System status - AUTOMATIC
In AUTOMATIC mode the brightness and temperature sensors, if enabled, manage motor
movement according to the following table:

OPERATIONAL MODES

Mar 15:22
AUTOMATION
Mode
Manual
Select
Save
31
A and C buttons: to go
Mar 15:22
from one function list to
MAIN
the next
Mode
Automation
Manual B button: to select the
Programming
item desired
Settings
LFT button: returns to
Sensors Test
TEST
Main Menu without saving
RT button: saves and
Select
Save
returns to the Programming
screen