Programming For Daily Use; Enable The Sensors; Adjust The Temperature And Brightness Sensor Thresholds - CHERUBINI Skipper Senso Instructions Manual

Remote control with integrated brightness and temperature sensor for indoor

Hide thumbs

Table Of Contents

Table of Contents

Enable the sensors:

Both sensors are factory enabled.

To disable or enable the brightness or temperature sensors, take the following steps from

the Main Menu:

Mar 15:22

MAIN

Mode

Automation

Manual

Programming

Settings

Sensors Test

TEST

Select

Save

Adjust the temperature and brightness sensor thresholds:

From the "System Status" screen it is possible to quickly access and adjust the temperature

and brightness sensor thresholds. Proceed as follows:

Mar 15:22

SYSTEM STATUS

Automatic

Brightness: 0135

Temperature: 20 °C

Thresh./Main menu

Quick start

The factory settings are the following:

Brightness: 500 (from 0 to 1000)

Temperature: 35° (from 0° C to 50° C)

For adjustment of the Brightness Sensor, see also "Adjust the hysteresis frame and the

Brightness threshold" on the following page.

The Temperature sensor is managed by the Season Option; the threshold value indicates:

- In "SUMMER": the maximum temperature that may be reached in the environment,

above which the sensor commands the blind/venetian blind to close or the awning to

open.

- In "WINTER": the minimum temperature that may be reached in the environment, below

which the sensor commands the blind/venetian blind to open or the awning to close.

ATTENTION! The temperature value MUST NOT correspond to the ideal

temperature for the room being controlled.