Table of Contents
Advertisement
AUTOMATIC TIMETABLE function (option to be enabled)
Enabling this function the system works in AUTOMATIC mode only within the timetable
set by the user (factory settings: 8 – 20).
- When the timetable is started the automation enables management of the brightness.
- When the timetable expires, and when the light falls below the twilight threshold, the
device is given the command to close completely (DOWN if blinds/ venetian blind, UP
if awning).
In the operation timetable the time is displayed in black; outside the timetable it is
displayed in grey.
It is always possible to control the motor manually with the A, B and C buttons. This
movement disables automatic operation for a time that may be set by the user (see
"Setting the Automatic Disable time", page 36).
A brightness level lower than the twilight threshold temporarily disables the automation
(red hand displayed). When the timetable expires, the command is given to close, in any
case. The manual controls (A, B and C buttons) remain in any case active. To enable the
automation again, the brightness sensor must be exposed to enough light to again fall
within the hysteresis frame.
Setting the Automatic Timetable function:
To activate the Automatic Timetable function, do the following:
Mar 15:22
MAIN
Mode
Automation
Manual
Programming
Settings
Sensors Test
TEST
Select
Save
Select "Enable"; at this point it is possible to set the timetable.
Value set at the factory: 8-20.
Mar 15:22
PROGRAMMING
Device
Timetable
8:00
Sensors enabling
Hysteresis
h
Season opt.
Select
33
B button: to go from one
Mar 15:22
screen to another
TIMETABLE
A-C buttons: to set the
Enable
values desired
:
Start Time
08
00
LFT button: returns to
:
End Time
20
00
the Programming Screen
without saving
Manual Disab. 000
RT button: saves
Select
Save
and returns to the
Programming screen
Advertisement
Table of Contents
