Modify A Device; Delete A Device - CHERUBINI Skipper Senso Instructions Manual

P 6To execute "storing of other remote controls" on two LCD remote controls:
rocedure
B
A
+ B B
2sec
Already stored LCD remote control LCD remote control to be stored

MODIFY A DEVICE

On Skipper Senso there is already a blind type device set with the name "Device 01". If
the device name or type is to be changed then proceed in the following manner:
Main / Programming / Device / Modify
-"Name": in order to customize the device name (maximum 16 characters)
Create the required name using the keyboard (see page 28). To quit: ENTER.
-"Type": to classify the device (blind, awning, venetian blind). After selecting, the system
automatically goes back to the screen "NEW DEVICE". To quit: BACK.
To save the changes: SAVE.

DELETE A DEVICE

If a new device is to be memorised on Skipper Senso, it is necessary to first proceed with
the deletion of the current device. Proceed as follows:
Main / Programming / Device / Delete / DELETE
When requested, verify successful deletion with the UP/DOWN/STOP buttons.
Once the check has been made, press END PROCEDURE.
43